0

Out of 0 Ratings

Owner's of the Frigidaire Washer Front Load gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 26
 
12
To add options, press the corresponding options buttons
to illuminate the selections desired. To delete options,
press the options buttons again and the indicator lights
will turn off. Some options require a “press & hold”
effort to activate or deactivate the secondary function.
Not all options are available on every model. To protect your
fabrics, not all options are available with every cycle. If an
option is not appropriate for the cycle, the indicator will not
light. Occasionally, a setting and option in the same cycle
will con ict with each other, like no spin (or low spin)
and energy saver. When this happens, the energy
saver option will override any incompatible selections.
add steam
Select this option to add approximately 20 minutes
of tumbling in steam during the wash cycle. It is
recommended for heavily soiled loads to help enhance the
release of tough stains from fabrics after initial agitation.
stain clean
Use the stain clean option to add a 5-minute soak
in the middle of the wash portion of the heavy duty,
whites, normal, casual, and delicates cycles.
Cycle Options
OPERATING INSTRUCTIONS
chime (press & hold)
A signal will sound at the end of the cycle if this option
is selected.
delay start
Press delay start to select a wash time convenient
to your schedule or during off peak energy hours.
The delay time selected will be displayed and begin
counting down when you select Start.
max ll (press & hold)
Increase the water ll level of the agitation portion of
any wash cycle.
fresh rinse
Use this option when additional rinsing is desired to
remove excess dirt and detergent. It is recommended
for heavily soiled loads or if household members have
sensitive skin.
clean washer
To clean and freshen the washer, perform the clean
washer cycle. Add bleach according to instructions
in “Inside Routine Cleaning (Preventive)”, turn cycle
selector to correct position, press clean washer and
then START when prompted.
This maintenance cycle uses hot water and two rinses
to remove residue that may cause odor. See “Inside
Routine Cleaning (Preventive)” for detailed information
about the clean washer cycle.
control lock
To lock the controls between cycles, press and hold the
control lock button for 5 seconds. Repeat to unlock
the controls when you are ready to operate the washer.
Use this feature to reduce the likelihood of accidental
operation by children.
IMPORTANT
• If steam is selected, rinse temperatures will be
elevated.
• If washer is paused during a steam wash cycle, the
door will remain locked due to higher temperature in
drum. DO NOT force open - it will unlock upon cooling.
• During a steam cycle you may notice steam exiting
from the rear vent of the washer - this is normal and
not cause for alarm.
NOTE
To change the options after the cycle starts, press pause,
adjust the setting and press START to resume the cycle.
NOTE
• Steam may not necessarily be visible inside drum
during a steam wash cycle.
• Steam may not be present during entire steam wash
cycle.
NOTE
The washer will automatically prompt you to run the
clean washer cycle every 50 cycles. You may press
the cancel button to manually perform the cycle at
another time.
Turn cycle selector
to this position.
energy saver
The energy saver option defaults to a cold temperature
setting (in most cycles) and also extracts more water to
reduce drying time.
Press clean washer
button to enter clean
washer cycle.